Tag Archives: in-cylinder pressure

Closed Loop Ignition Timing Control

I have been busy over the last few weeks with various things, but have now completed most of the practical work on my project and am now at the stage of writing up the report/dissertation. I have successfully managed to achieve closed loop ignition timing control by using the Stellaris Launchpad development board to directly interface with the optical encoder on the engine and the pressure sensor charge amplifier (this replaces the AVL IndiSet 620 in my system).

ECU in black on left, angle of peak pressure and optical encoder interface on right. Connected together via serial

Continue reading

High Speed ADCs and Interfacing with Texas Instruments ADS8321

I needed a high speed ADC for sampling in cylinder pressure for my ECU, and settled on trying a few from Texas Instruments. I am using an optical encoder on the engine which provides 720 pulses per revolution . If I took a sample every pulse, then at 6000 RPM (100 Hz) then I would be looking at about 720 * 100 Hz = 72,000 Samples per Second (SPS) or 72kHz ( although I realise now that I could take a sample on each edge, resulting in 1440 samples per revolution, or 144,000 SPS). That’s pretty high speed, considering most ADCs built into microcontrollers take a few microseconds to perform their conversion which results in a sampling rate of perhaps up to 50,000 SPS max for the Arduino for example. DSP chips or higher end micros probably have better performance, but for the sake of learning, I fancied trying to use an external ADC anyway.

8 MSOP breakout

Continue reading

Getting High Tech

Just a quick one on what I’ve been up to the last few days. I now have the engine set up inside so that I don’t have to keep pushing it outside or waiting for the rain to stop. I’ve also set up an optical encoder, in-cylinder pressure sensor, and AVL IndiSet high speed data acquisition unit to capture data on a 0.25 degree crank angle resolution.

Extended exhaust manifold for indoor running

Continue reading